Home / Door Threshold / Exterior Door Threshold Seal / Garage Door Weather Seal Threshold Bottom 12 Foot Ways To Open A Locked Change Front Lock Types Of Knob Locks Electronic System No Drill Patio Handle With Self
Joanna Malone Door Threshold January 14th, 2020 - 03:32:40
The cost to protecting doors jambs and thresholds are well worth the small investment. The average cost for a cardboard door protector one cardboard jamb protector and tape for the threshold is less than 25.00 The cost to replace just a door alone can range from several hundred dollars to several thousand dollars. In addition many door protectors and jamb protectors are reusable so the long term cost for protection is even less. Experienced contractors recognize the importance of protecting the entry doors jambs and thresholds. Doing so is a great way to increase customer satisfaction and keep job site damage to a minimum.
With the rough opening clean and prepped for the new door and jamb move the system into place as one with door hung on hinges. Temporarily shim the side jambs tight top and bottom ends in the rough opening. Temporary shims at the bottom hinge may also be required to straighten door sag. The top hinge will sag just be aware that you will compensate for it later with shims and a screw to snug it when the door is installed permanently. Use of a level isnt necessary just align the jambs flush with the interior plaster and shift shims to square the door in the jambs with even spacing reveal.
Ive learned by the hard way of experience that its necessary to remove old existing jambs carefully. If directly fastened to masonry with cut nails jambs removal may break out the cinderblock unless the jambs are cut into short manageable lengths. An out of level concrete threshold step can be ground flat by a concrete cutting subcontractor or the door threshold can be adjusted by unscrewing and repositioning in the jamb by the amount out of level. Any attached brickmold and casing must be removed from the jambs to make installation easier with shimming. Also brickmold will probably have to be ripped in width to fit the overall brick opening width and height.
Several sill manufacturers provide plastic threshold protection that is specific to the model of sill they are selling. Unfortunately heavy duty plastic protectors are not available for every type of entry threshold so the protection is not easy to obtain. There is one surface protection company on the west coast that does inventory plastic threshold protection for two of the most common sill profiles. For protecting sliding door tracks there are two types of threshold protection. The first is a hinged plastic protection that flips over the tracks of sliding doors to keep them clean from debris.
3. SECURITY Most folding doors will feature a high security locking system but many still use face fixed or flag hinges that can pose a possible security issue and allow the hinges to be removed from the outside when the door is closed. Some upvc bifold doors may also use an exposed gearing system that is accessible from the outside of the door when the door is closed which can also pose a possible security threat. You can eliminate these potential security problems by ensuring you choose a folding door that has fully concealed gearing and hinge fixings.
UV protective tape has chemicals in both the tape and adhesive that block UV rays and make the tape resistant to both sunlight and heat. It can be used in both hot and cold climates without the worry of adhesive transfer resulting in a quick and clean removal upon project completion. Although more expensive than other tapes UV protective tape is very cost effective when the costs of clean up or repainting of entry thresholds are considered. Blue masking tape and blue sill tapes are the most common tapes for protecting thresholds. These low cost tapes work for short term protection only in areas of low heat or sunlight.